【 Weak current College 】 to CPU heatsink paste the correct paint---Power By 【 China power house network 】

Keen on overclocking, the transformation of the DIYer were aware of the importance of the heat, but seemingly simple coating thermal paste (grease) method, but it is a lot of players the most easy to ignore.

Because the surface of the CPU Die part is too small, plus some CPU (e.g. AMDAthlonXP) surface is exposed by the capacitor, resistor and small Golden Bridge, using thermal paste incorrectly may result in short time the CPU burning, AthlonXP installation is still the most difficult DIY beginner a graduation exam. For this reason, today, I will discuss with you what kind of coating thermal paste method is the most appropriate.

First, the heat paste more or less?

To the "more" and "less" two words in a hard selected as standard, the author would like to advise you DIY beginner less Moser. Of course, the thermal paste is used too many or too few are inappropriate, but used thermal paste knows, usually too much thermal paste extruder, with thermal paste is essential to know how to control the intensity of squeezing the anointing.

Second, the proposed standard extruded heat sink paste

1. extrusion, thermal paste nozzle pointing to the surface of the CPU Die Center. Don't like squeezing toothpaste that runs from left to right, because when you install the heatsink will put pressure on both sides of the thermal paste Die pushed outward, excess heat paste will be pushed to near capacity.

2.Athlon series CPU Die part is very small, so just Extrusion Die area accounted for approximately 1/4 cent thermal paste (Figure 1).

The protective cover of Die 3.P4CPU larger, extrusion heatsink paste in occupies about Extrusion Die area around 1/9. Some people think that the surface should be covered with P4 thermal paste, but in fact this is not necessary. P4 surface thermal paste is huddled diameter close to metal cover side of the circle is enough (as in Figure 2), too much CPU socket instead easily contaminated and motherboard.

4. If the thermal paste is slightly more to squeeze out the above ratio, you can use the extra thermal paper paste gently erase.

5. If extrusion heat paste component too much, it's best to Die from pollution in some completely clean and try again. Because if you don't understand a certain brand of thermal conductivity of plaster, stain resistance, capacitance and low thermal paste is Jinqiao enough to cause a short circuit the CPU burn-out.