【 Weak current College 】 memory and panic

1. power on the

Because memory reasons against such failures usually is because the memory and motherboard memory slot is bad, just use the eraser wiping their gold finger back and forth part to solve the problem (do not use alcohol to clean), there is a memory corruption or motherboard memory slot problems can also generate this type of failure.

Because memory causes post no display fault, host speakers generally long beep (for
AwardBios)

Second, the windows system running unstable, and often generating illegal errors

Against such failures are typically poor quality memory chip or software causes, if determined to be the reason why only replace the memory stick.

Third, the windows registry without undue damage to the tips often require user recovery

This type of failure usually is because the memory stick caused by poor quality, very difficult to repair, replace.

4. windows often automatically goes into safe mode

This type of failure usually is due to the motherboard is not compatible with memory stick or memory stick caused by poor quality, common in some PC133 memory for PC133 memory stick is not supported by the motherboard, you can try in the CMOS settings in reducing memory read speed if I can fix the problem, if not, you only replace the memory stick.

5. random panic

Such failures are typically uses several different chip memory, because the memory speed produces a time difference causing panic, this can reduce the memory within the CMOS settings be resolved, otherwise the speed, but use the same model of memory. Another possibility is the memory stick is not compatible with the motherboard, this phenomenon is generally rare, there may also be memory and motherboard bad cause computer random panic, this phenomenon is more common.

After six, memory, increasing the system resources instead of reducing the

Such phenomena are typically not compatible motherboard and memory, are common in the PC133 memory chips used in some unsupported PC133 memory boards, even if the system reload cannot resolve the problem.

7. windows startup, load when himem.sys high-end memory file system prompts some addresses this issue in question is generally due to memory stick for certain chip damage caused, the solution may see the following memory maintenance a method.

8. run some software often out-of-memory message

This phenomenon is generally due to insufficient space remaining in the system tray, you can remove some unnecessary files, keep some space, and generally remain in 300M or so suitable.

9. installing Windows from the hard disk boot for the detection of disk space, the system prompts on memory

Such failures are typically in the config.sys file, the user has joined the emm386.exe files, as long as it can be screened out.

In fact, from the hard disk to install Windows DOS mode boot method is more complex and slow, it must be installed on your hard disk, and also DOS file config.sys and autoexec.bat files configured, if improper configuration file, also raises a host of cases of unforeseen failures, for starters are not practical. Second, after the success of the winows mount, because each time the system will call into the config.sys and autoexec.bat files to drive optical drive, making the system startup time extension, if shield off the config.sys and autoexec.bat, Windows sometimes optical drive is not working properly.

10. install the windows to the system configuration is an illegal errors

Such failures are typically caused by memory stick is damaged, you can press memory maintenance a method to resolve, if not, you only replace the memory stick.

When you start Windows, the system automatically restarts multiple times

This type of failure usually is due to the memory stick or power quality problems, of course, the system restart may be CPU cooling-performing or other person for failure to do this, only used as a process step by step.

12. memory maintenance a method

Occurs after several failures, if memory corruption or chip quality no, if the conditions do not allow the use of a soldering iron to the side of the chip memory is removed and see if I can fix the problem, if no pulls off another side of the chips until the success so far (so I am afraid to repair welding cell phone may reach). Of course, conditional testing using oscilloscope that twice), after using this method, because the side of the memory chip removing, so only half of the available memory, for example, there are also available, 32M 64M as this, in the case of small amounts of memory, there would be no maintenance necessary.