Weak current college】 【resolved XP system installation notes.

Refer to installing XP system members familiar with the global usage maximum system height by a user, but XP is installed on all systems the most prone to problems of the system, whether it is a software or a system installation will need to unzip or compressed file, the file big words may require dozens of minutes, it only takes a few seconds, while XP system is installed on all systems the longest system software, sometimes the installation take nearly an hour, when the installation is complete, and always arise, sometimes a few times even reload cannot resolve that many users feel unsure what went wrong, on this on XP system installation considerations for resolution

Unzip the package, copy the temporary file

Install the system software, the General will file is installed in c drive, the system will automatically create a new folder, and then will install files into this folder. XP-compressed installation file has reached hundreds of megabytes, copied to the temporary directory where there are two or three hundred megabytes, so if a DOS installation "SMARTDRV.EXE must be loaded, forget the words" installation procedure will be extended several times, attention to the "CONFIG.SYS" RI "HIMEM.SYS is loaded first, otherwise light" type "SMARTDRV" is invalid. Generally this process to 8-15 minutes to hardware performance. Not loaded "SMARTDRV" may be the copy process is especially long, thought dead but forced restart damaged partition table.

Continue to copy, extract files and detect Plug and Play device

Enter the XP install graphical interface, Setup starts copying files continue to mainly to install XP's official directory to generate the application group and menus, etc. Question XP installation has entered the stage, the system will detect the hardware configuration, in order to plug in the hardware device to install the correct driver.

Many of the compatibility of hardware will step out of the blue screen or automatic or panic, if overclocked system or the use of poor quality and equipment, the chance of a problem, this is a potential panic after the risk of data loss.

Setup over the boot sector

In the copy temporary files, XP Setup to the c drive boot sector write load NT kernel startup capital required. If the installation program copies files when forced to press the RESET restart, or crash occurs, the blackout, accidental, then XP installation over probably haven't finished, the system may crash, even if the original installing with other versions of Windows XP is also invalid because the installation program sets its boot file with the highest priority.

Therefore you must prepare a DOS system disk in case there is a problem with the system tray after booting into the installation directory again XP to start the Setup program to repair. If this is a normal exit, XP Setup automatically the next time you continue installation tasks. The takeover process is a very important step.
After the installation is complete, the first time you start

Testing out the device and copy over the files, XP will again require the user to restart the computer, so that the driver is loaded, the entry into force of the new machines are generally 2 to 3 minutes to complete this procedure. When XP was installed, you should see the blue background of the "Welcome" message, if the motherboard CMOS without electricity, causing the system date is set to 1999 such invalid date, the date of inspection mechanism of XP in "Welcome" interface in lock computer, without any prompts or any options, in addition to a mouse move outside the remaining death, if you don't like to pay attention to date, regardless of any repair operations will be invalid, it is likely that the installation failed and format the partition, loss of data.

Through the introduction of small series of the above, I believe the attention on the XP system installed, while installing XP is a very common operation, but if you want a smooth installation process, you still need to be careful to do every link.

Check the partition and the original version of Windows

Starting from Windows2000, Microsoft installer detection has been with the user's hard disk and partitions. If the partition is still not formatted, the installer also provides the ability to format the partition, can be formatted as FAT, FAT32, NTFS, Microsoft recommended format is NTFS, and appears in the list will be installed on a partition formatted as NTFS.

If the user selects is formatted as NTFS, XP Setup when in the transformation of format in the middle of panic, might be corrupted partition table, but you cannot use NTFS DOS boot, some users may be confused, forced to use FDISK repartition and loss of all data.