】 【Weak current College recognizes the wireless network setup five typical questions.

Now more and more enterprises adopting wireless network connection, but because everyone on the wireless network management, maintenance of low, resulting in trouble ...

1. product selection

1. If using a wireless network, not only to consider wireless products of quality, performance and price, but also focused on the product vendor or channel capacity and skills to support the implementation of the capacity and multiple select several companies product trial tests.

2. Select the right product, the subsequent product preferably the selection of the same company. This I think is key. Our initial product is Macromate company MOB-811 products, followed by the project will use a different brand of products not only to post-sales support brought trouble, network transmission quality, or to reuse the same products. Use the same company's product is the best device compatibility is good, can make the device performance play more exciting, if there is a doubt, not because of the different products and each other's back.

Second, the wireless network setup typical questions

1. the installation position is not selected, the subsequent need to replace the installation location.

Approach: in the choose the installation location when it is first necessary to ensure the antenna should have sufficient Visual space, then consider installing construction maintenance can facilitate (after all, as long as the installation of antenna, maintenance less likely); also to seek the views of the upper deck company to consider whether or not we can influence the appearance, but also to understand the architecture of the selected location will be the possibility of other uses.

2. when the installation is not fully secure, resulting in a strong wind blew the entire antenna rod.

Approach: If the antenna does not pass the antenna pole fixed on the wall of the building, should increase the antenna Rod base weight, you should find some wire, from four angles straining the antenna pole fixed.

3. install location often people come to the attention crash, antenna transfer for the antenna, resulting in the emergence of network transfer.

Treatment methods: require company engineering Dept in antenna near the display obvious reminder flag, and use of isolation in quarantine.

4. when the installation is not considering antenna near the advertising banners, banner was blown when strong winds to the antenna, pulling the antenna, the impact of the signal transmission.

Approach: a advertising banner locations or later here near to add advertising banners, advance and communicate relevant departments of the company, banners to fixed not to affect the antenna.

5. when the installation is not doing well, waterproof affected devices such as a wireless bridge.

Treatment methods: feedback cable through wall of absorbent very strong material handling; feedback cable not from the top down into the wireless bridge the Cabinet, but should be the advancement, so in case of water along the feedback cable into the Interior are dropping to the ground.

Also see: used to connect an outdoor antenna and wireless bridge antenna feedback cable not too long, the longer the result of feedback cable attenuation signal gain faster.