Weak current college】 【ten way to solve computer appears unable to boot failure.

Post problems will emerge after the English of, of contains very important information, read the information that can solve some small problems, but the English beat part of friends, here are some common BIOS of explanation, we can refer to.

1.CMOSbatteryfailed

Chinese: CMOS battery failure.

Explanation: This shows the CMOS battery is almost out of power, as long as the replacement of the battery.

2.CMOSchecksumerror-Defaultsloaded

Chinese: CMOS executing all check error discovered, to load the system default value.

Explanation: in general the word is that the battery is almost out of power, you can try changing the battery, if the problem still not solved, there may be problems shows CMOSRAM, if not over one year to the dealer for a motherboard, a year will allow resellers to manufacturers fix!

3.PressESCtoskipmemorytest

Chinese: ongoing memory check, you can press ESC to skip.

Explanation: this is because there is no set within the CMOS to skip the memory of the second, third and fourth test, post executes four times the memory test, of course, you can press ESC to end the memory check, but every time you want to do too much trouble, you can access after selecting BIOSFEATURSSETUP COMS set, be QuickPowerOnSelfTest is set to Enabled, save it and restart the computer.

4.Keyboarderrorornokeyboardpresent

Chinese: keyboard error or no keyboard.

Explanation: check the keyboard cable is loose or damaged.

5.Harddiskinstallfailure

Chinese: hard drive installation failed.

Explanation: this is because the drive's power cord or cable may not connected or hard drive jumper is set incorrectly. You can check the root of the hard disk is plugged in line to see the same root data cable on two hard drive jumper settings are the same, if you like, as long as the two hard drive jumper settings are not the same you can (a set as Master and the other as Slave).

6.Secondaryslavehardfail

Chinese: detection from disk failure.

Explanation: the CMOS settings may be inappropriate, for example from the disk but in CMOS is set to a slave, then an error occurs, you can enter the COMS set select IDEHDDAUTODETECTION automatically detect the hard drive. It may also be hard drive power cable and data cable may not connected or hard drive jumper is set incorrectly, solution reference section 5.

7.FloppyDisk (s) fail or FloppyDisk (s) fail (80) or FloppyDisk (s) fail (40)

Chinese: no driver floppy disk drive.

Explanation: you are prompted to find the floppy drive, see floppy drive power cable and data cable is loose or is wrong, or is the floppy drive into another computer's subnet, give it a try, if these are not, then had to buy another, better in the floppy drive is not expensive.

8.Harddisk(s)diagnosisfail

Chinese: an error occurred while performing a hard disk diagnosis.

Explanation: this problem usually means that the hard disk itself fails, you can put the hard disk onto another camera on a try, if the problem is not resolved, you can only go to fix it.

9.Memorytestfail

Chinese: memory test failure.

Explanation: Reseat the memory modules, see if you can solve this problem occurs because memory stick General mutually incompatible, go-for-one!

10.Overrideenable-Defaultsloaded

Chinese: current CMOS settings cannot start the system, load BIOS default values in order to boot the system.

Explanation: General-chun as pei buildings Mody moustache COMS set error within, as long as into the COMS set select LOADSETUPDEFAULTS loading system to the original settings and then restart it.